Look in the settings for controllers in the simulator (I do not use P3D so cannot point you). Use of the two knobs if I recall correctly require use of Conditions with underlying Variables. Most of the buttons are set as Variables. Note the presence of two separate areas for Variables. Look both above and below the blue Close box in the image I am including.

So watch what he does as he makes settings because he does not always mention all of what he is doing. But there is a subsection under Conditions that is also named Variables. It is confusing because under Events are two groups, one Conditions, the other Variables. Some items are set as Conditions, and others as Variables, For Conditions there is a small grayed out slider that has to be slid to the right to then set Condition Variables. Watch very carefully the difference between Event 'Conditions' and Event 'Variables' as he moves through the video. Just takes a bit of time to decipher it all. Once I had the light go on I got on a roll. It is rather dry but if you stick with it, and use pause, and backup a few times you can sort it out. There is a video tutorial at the link below. Am I making something too difficult here? Any help on the editing profiles would be much appreciated.Īny help on the editing profiles would be much appreciated. I find the user manual, or lack thereof, to be ridiculous. Fortunately all of my Axis' work fine being mapped through P3D. I actually use that button to cycle camera views in chaseplane, which I have working, but it keeps turning off my auto pilot. I prefer the small white button for that, which I mapped through P3D, but I want to disconnect the red button. Also, on my yoke the red button disengages the auto pilot. Since there are no LNAV/VNAV buttons on the TQ I would at least like to have VS engage VS in my aircraft but I can't figure out the profile editor. VS engages LVL CHG REV engages LNAV, ALT engages VNAV and IAS engages VS. On the auto pilot panel I was able to map the HDG and APP buttons within P3D to correspond correctly to my 737, but the other buttons are not correct. What I'm focusing on right now is trying to edit button functions. Wow, not exactly plug and play for P3D and the PMDG 737 nor is there nearly as much setup help online as there is for MSFS but after much time I made good progress, downloading an NGXu profile from Aerosoft got me moving in the right direction. I hooked up my new alpha yoke and bravo throttle quadrant today.

Does fsuipc work with prepar3d v4